I would like to program an ozone generator to run for 15 minutes out of every hour. If I use the standard ORP program to turn the ozone generator on when ORP < a certain value and off when ORP > the high value, the ORP shoots up quicker than I would really like. In short, the generator is putting out more ozone than I need even on the lowest setting so I need to limit the run time. I've used an OSC statement to do this which works nicely but I can't figure out how to incorporate the low on setting into my program.
Here's what I have now which works fine with the exception of including the low ORP range:
[Ozone]
Fallback OFF
OSC 000:00/015:00/045:00 Then ON
If ORP > 380 Then OFF
If Output AirPump = OFF Then OFF
If Output Skimmer = OFF Then OFF
If I incorporate a statement in my Ozone outlet such as If ORP < 360 Then ON, it overrides my OSC statement and turns the outlet on. If I do the same with a virtual outlet, it will override the OSC statement as well. What I'd really like to do is have the outlet on for 15 minutes every hour but only if the ORP is < 360. I also need it to turn off if ORP > 380. I've tried a number of virtual outlet options to no avail.
Is this even possible or is it just best to tweak my OSC statement to keep my ORP in check and include the OFF statement at the high range?
Thanks
Bookmarks