So I just purchased a new ATK. I am currently using it in standalone mode until I get an apex controller when tax returns come around. So I just got it all set up, according to the getting started, I plugged it in, and the led started immediately blue. A few seconds later, the pump started humming. A few seconds after that, water started spraying from the QD adapter on the pump. I unplugged it, took the water line from the QD adapter, and reconnected it, pushing it firmly into the adapter. I then plugged it back in. once again, the led glowed blue, and a few seconds later the pump whirred back on again. This time it only leaked from the adapter instead of spraying several feet in the air. I let it go, to see what happened. The pump ran for a few minutes, while water dripped from under the float valve. Eventually, the led turned green again, but the pump sounded like it was still running. it went on like this, with water still leaking from both ends for several minutes, until finally the led blinked red, and I unplugged it. so... my concerns.
1 the leaking QD adapter
2 the pump staying on for so long after green light
3 it kinda looked like the float valve was closed and it was just leaking. there wasn't much flow going in
4 the error message
any ideas
Bookmarks