Results 1 to 2 of 2

Thread: calibrating conductivity probe without a display

  1. #1
    Banned
    Join Date
    Jun 2016
    Location
    PST
    Posts
    29

    calibrating conductivity probe without a display

    How do I calibrate conductivity probe without a display on the classic? I used to be able to go to the classic interface I believe in the configuration tab/probe section but I get an error loading this page. is there a way to calibrate this probe without an apex display?

    Please advise?

  2. #2
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    You need to either use the display or use the input/probe setup section to do the calibration. If the page won't load, chances are the webpages don't match the firmware. Try updating both the base firmware and the webpages and it should load just fine.

    You might be an engineer if...You have no life and can prove it mathematically.

Similar Threads

  1. Help! Apex 2016 Conductivity Probe not calibrating
    By Seanislav in forum AquaBus Modules, Probes, and Breakout Boxes
    Replies: 13
    Last Post: 04-15-2019, 13:41
  2. Help! Conductivity Probe not calibrating
    By GazzarUK in forum A2 Apex/ApexEL and A3 Apex Pro/Apex/Apex Jr
    Replies: 4
    Last Post: 08-30-2018, 12:20
  3. Probe (Ph and Conductivity), issues after re-calibrating
    By neiltus in forum AquaBus Modules, Probes, and Breakout Boxes
    Replies: 0
    Last Post: 11-04-2016, 07:01
  4. Help! having issues calibrating conductivity probe
    By 860636 in forum AquaBus Modules, Probes, and Breakout Boxes
    Replies: 0
    Last Post: 03-21-2015, 18:47
  5. Help! Calibrating a pH Probe Without Display Module
    By maxwellag in forum Apex Programming for Dosing, ATO, and AWC
    Replies: 0
    Last Post: 01-06-2014, 05:51

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •