hi, how and what times do i put in a 24hr period for dosing two part dosing alk and cal at different times so they don't dose at the same time.
Thanks mike
hi, how and what times do i put in a 24hr period for dosing two part dosing alk and cal at different times so they don't dose at the same time.
Thanks mike
As long as the two don't dose exactly the same volume, just entering the volumes will space them out a bit naturally and if/when the two are dosed at similar times the values are so small they won't precipitate each other.
You might be an engineer if...You have no life and can prove it mathematically.
There was a thread on this awhile ago, if I recall the technique was to set the schedules as 00:05 to 23:59 and 00:00 to 23:59 respectively. The offset in start time should space em out. I don't disagree with what zombie said, but some folks run the outputs close together so just in case.
Chad
Bookmarks