Hi,
Background -
I bought a used Apex Controller, which came with the probes and all. The probes are all dried out and eventually I will replace them.
I went and reset the Apex, started with blue and went into apex.local and followed all the instructions, connected the probes. Did get some readings.
Installed the app on my Iphone, used the link code and set it up. The app on my phone said that there was a firmware update available, I went and updated the firmware.
I thought at this point I was all set.
Problem -
The EB832 was blinking a rapid orange. This must have been blinking a rapid orange - prior to the FW update itself, I was too excited to notice anything.
I googled it up and i found that it is in Bootloader mode.
Please suggest how I should be proceeding, i did come across https://www.neptunesystems.com/downl...e-guide-V2.pdf
But I am not sure if the above article is applicable to EB832?
Please advice.
Thank you,
Vamsi.
Bookmarks