I have the Neptune atk in a frag tank and when the water is low on the first sensor the pump kicks on but the float valve is stopping water from coming in. Any thoughts?
I have the Neptune atk in a frag tank and when the water is low on the first sensor the pump kicks on but the float valve is stopping water from coming in. Any thoughts?
When you say the first sensor do you mean the hi sensor? Posting your programming from the ATK outlet would help to.
Chad
Is something upside down?
I had the same problem, then I carefully adjusted the float with to the proper location by pulling up on it. There will be a clicking noise as it moves. I needed 2 clicks to make it where it would allow flow and shut off at the high switch
Position the float at the middle of the range - about 4 clicks down from straight.
Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.
Ok I’ll give that a try thanks
Wow it fixed the problem. I like how hey did that.
Bookmarks