Results 1 to 4 of 4

Thread: Ald

  1. #1
    Regular Vistor
    Join Date
    Mar 2016
    Location
    Miami
    Posts
    32

    Ald

    So I had installed this last year and wanted to test the system now by placing water under sensor. Nothing happened. Now I find I cannot find where it is even installed. Which outlet on fusion etc. and no alarms seem to be programmed. How do I proceed to correct this as I have lots of other wires and modules connected !


    Sent from my iPad using Tapatalk

  2. #2
    Master Control Freak RussM's Avatar
    Join Date
    Dec 2012
    Location
    California - US Pacific
    Posts
    22,464
    There are no outputs associated with the ALDs. The ALD has 4 switch inputs, which you then test to see of they are OPEN (dry) or CLOSED (wet) in programming used in alarm outputs to turn the alarm ON, and other outputs you may which to turn OFF if a leak is detected.

    I encourage you run through the ALD Get Started Guide. https://www.neptunesystems.com/getstarted/
    Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.

  3. #3
    Regular Vistor
    Join Date
    Mar 2016
    Location
    Miami
    Posts
    32
    Ok but I have a few of these switches. How can I tell which 4 inputs are tied to the ald


    Sent from my iPad using Tapatalk

  4. #4
    Master Control Freak RussM's Avatar
    Join Date
    Dec 2012
    Location
    California - US Pacific
    Posts
    22,464
    The ALD's 4 inputs will (by default) have names of Swx#_1, Swx#_2, Swx#_3, and Swx#_4. The # is the Aquabus address of the ALD. Look at the Modules setup page in the Classic Dashboard; in the table at the bottom of that page, you can see what Aquabus address the ALD has.
    Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.

Similar Threads

  1. Cannot 'see' ALD
    By uwish in forum Apex Classic Dashboard
    Replies: 4
    Last Post: 12-17-2018, 16:45
  2. Question: ALD
    By steven in forum AquaBus Modules, Probes, and Breakout Boxes
    Replies: 0
    Last Post: 09-08-2016, 09:15
  3. Question: ALD
    By steven in forum APEX Fusion
    Replies: 0
    Last Post: 09-08-2016, 09:15
  4. Help! Ald help
    By allred in forum AquaBus Modules, Probes, and Breakout Boxes
    Replies: 0
    Last Post: 04-22-2014, 20:05
  5. ALD Other uses?
    By Mal7887 in forum Misc Apex Usage & Programming
    Replies: 5
    Last Post: 01-26-2014, 18:56

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •