Help! 2nd pH probe reading correctly but not connecting to outlet

[meliness]

Hi there,
I set up my second pH probe using the instructions shown here: https://www.youtube.com/watch?v=qPvKaSC0vuw

Both probes are displaying the pH values correctly on the AquaController screen. I named my probes pH1 and pH2. However, when I go to the outlet for pH 2 (named Ph____2__) in Program Outlet, only probe pH1 is listed. When I hit the arrow keys, probe pH2 is not listed as an option. Therefore, both of my outlets (CO2_3_7 and Ph____2_) are controlled by pH1.

How do I change the settings so outlet Ph____2__ is controlled by probe pH2?

I do not have the web interface set up currently and am using only the AquaController screen.

Thank you so much for your help!
-Melissa

[zombie]

Set up the web interface even if it's just the classic dashboard. The amount of time it will save in programming will more than outdo any time spent setting that up.

You might be an engineer if...You have no life and can prove it mathematically.

[jonlovisolo]

Agree, sorry. I can't help without some web type of interface

[meliness]

Thanks- I'm getting it set up today and updating firmware, hopefully that will help