No data or outlet logs.

[jmoney402]

I have the apex classic, and am having a hard time figuring out how to use the outlet logs and the data graphs.
Have had my aquarium down for a year, sure I missed something simple but I didn't see it in the last update page.

Sent from my SM-G920V using Tapatalk

[zombie]

Are you using fusion or the classic dashboard? What specific problem are you having? Your description is a bit vague.

You might be an engineer if...You have no life and can prove it mathematically.

[jmoney402]

Are you using fusion or the classic dashboard? What specific problem are you having? Your description is a bit vague.

You might be an engineer if...You have no life and can prove it mathematically.

Sorry for the vague question but I seemed to have figured it out, may have just been the time being off or something else.
I was flustered because I was having problems with my ATO and had no data logs to help diagnose. Turns out my problem is because of the fluctuation of water in theiling rollermat.
To combat this I changed ATO programing to come on just once an hour, any other known solutions around this?
Thanks for quick reply.

Sent from my SM-G920V using Tapatalk

[zombie]

Your problems with the outlet log was likely that you didn't check the "log enable" checkbox on that particular outlet.

I dont know what your ATO code is but this general approach is usually the best starting point for most people (coded for optical sensors. For floats, use CLOSED instead of open and vise versa)

Fallback OFF
Set OFF
If LowSw OPEN Then ON
If HighSw CLOSED Then OFF
When On > 005:00 Then OFF
Defer 000:30 Then ON
Defer 000:30 Then OFF
Min Time 030:00 Then OFF

You might be an engineer if...You have no life and can prove it mathematically.