WXM setup with APEX system

[Mikeforce72]

I have just unpacked my new Apex system and WXM module. I connected the APEX system pretty easily with all the directions provided by Neptune. However when trying to connect the WXM module all the directions I have found are dated. I connected the WXM with the provided aquabus cable and have been stuck there for the last few hours. I have two green lights but the module is not showing under modules in APEX Fusion. I am not able to make sure that is updated so I can begin to connect to my Radions and Vortechs. What am I missing? There isn't a troubleshooting guide that I have found.

[Mikeforce72]

I think I figured it out. I had to remove my apex from fusion and re-link it. Will having done this mean I need to re-calibrate my probes?

[rkpetersen]

So do you have the module available now in the modules list?

Have you tried these pages? There are quite a few steps to getting the Vortechs under WXM/Apex control, but when I did so, it all went smoothly.

https://www.neptunesystems.com/getstarted/wxm/radion/

https://www.neptunesystems.com/getstarted/wxm/vortech/

[Mikeforce72]

I do now have the radion modules showing. The vortechs are still eluding me. I have used both of those links. My issue with the radions seemed to be that the apex had stop talking to fusion (I noticed the temp hadnt changed in hours.) Once I reconnected the two the radions popped right up. Still not getting the vortechs to connect.