Hi I'd like to use one signal 0-10V and connect it to two diferent led drivers, is this possible ? The reason is one driver is for 1400mA (cree xte) and one for 900 mA (cree xpe).
Hi I'd like to use one signal 0-10V and connect it to two diferent led drivers, is this possible ? The reason is one driver is for 1400mA (cree xte) and one for 900 mA (cree xpe).
For almost all cases, yes. If you want to be extra careful, check the datasheet or contact the manufacturer to find out if the current draw is less than 10mA each from the signal wire at 10V
You might be an engineer if...You have no life and can prove it mathematically.
Bookmarks