Hi,
I woke up this morning and noticed my tank was quite loud. I looked and the water was lower then it should be. Checked my logs and notice my ATK hadn't turned on in over a day. It turned out the sensor was stuck on because of some salt build up. I cleaned the sensor and all was back to normal. I was trying to program my error messages to let me know if the ATO Switch 1 stays closed for longer then say an hour. However it doesn't seem to like what I was putting in. Anyone know the proper code for this?
This may not turn out to be a huge issue as I know now that I have to clean those sensors on a regular basis. Still wouldn't mind having some alert that would let me know if the ATK hasn't run in a while.
Thanks, Ryan
Bookmarks