Trying to better understand coding. Let's look at the below code from my Neptune ATK
When the pump runs greater than 5 minutes, it turns off the ATK (slider actually turns off and won't automatically turns on) and sets an alert via email with the code "If Error ATK_L Then ON"Code:Fallback OFF Set OFF If Swx5_1 OPEN Then ON If Swx5_2 CLOSED Then OFF When On > 005:00 Then OFF Defer 000:10 Then ON Defer 000:04 Then OFF Min Time 060:00 Then OFF
Any other "Then OFF" doesn't cause an alert. Is it because of the "When On > X" that is causing the alert?
Bookmarks