I have 4 mp40. Yesterday I bought a Qd-unit for one of my old pump. All 4 pump were connected to WXM and worked well. I switch the control unit and replace with the new qd-unit. I reset the control unit and then i set the unit so i get blue yellow. I open Apex fusion and go to Ouputs and I dont see the Pump!
I reset again and try again but no pump. Then I update wxm, but the same problem. I detach the Wxm, sam problem. Reset Apex, sam problem.
Then i replace the old controller, the pump starts, But i Dont see the pump at Outputs! But the pump is controlled by Apex....
So today i removed all pumps, deleted wxm and start all over again, but today I cant connect any pump....
BUT, two pumps still is controlled by Apex, but i dont see them in Apex.
So boring this is....
Bookmarks