I need to program my Apex for using my ATK optical sensor module with my DOS for use as an ATO. Can anyone please help with this?
I had been using a different peristaltic pump for my ATO but that pump failed yesterday and I have one open DOS head so I would like to use it for ATO. My previous programming for the dead peristaltic pump is below (it was a very slow pump so that's the reason for the very long on time of 999:00):
Fallback OFF
Set OFF
If Swx15_1 OPEN Then ON
If Swx15_2 CLOSED Then OFF
When On > 999:00 Then OFF
Defer 000:10 Then ON
Defer 000:10 Then OFF
Min Time 001:00 Then OFF
Swx15_1 is my low optical sensor.
Swx15_2 is my high optical sensor.
The DOS head that I want to use for ATO is DOS_11_1
Thank you very much for any help!
Bookmarks