Results 1 to 2 of 2

Thread: Help AWC setup not following dos profile

  1. #1
    New User
    Join Date
    Jan 2017
    Location
    Midland, TX
    Posts
    2

    Help AWC setup not following dos profile

    I have setup continuous auto water changes. Half a gallon a day or 1892.71ml.

    Today (day 2) it ran past the time and ml set...there are no "Advanced" parameters in the config for each dos pump.

    I have set the output profile to "Remove" just now. Do I need to reverse the plumbing?? Or does it still pump in the same direction?

    Untitled-1.jpg

  2. #2
    Master Control Freak RussM's Avatar
    Join Date
    Dec 2012
    Location
    California - US Pacific
    Posts
    22,464
    Make sure the DŌS slider tiles on the APEX Fusion dashboard are both in the AUTO position. It looks to me like they are both in the ON position.
    Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.

Similar Threads

  1. Help! New DOS Setup for AWC
    By ddrueckh in forum Apex Programming for Dosing, ATO, and AWC
    Replies: 35
    Last Post: 03-19-2019, 06:17
  2. Help! DOS dosing incorrect volumes (AWC setup)
    By jmheron in forum DŌS & DDR – Dosing and Fluid Metering System
    Replies: 4
    Last Post: 10-17-2018, 11:42
  3. DOS AWC - Setup Questions
    By jfouch in forum Misc Aquarium Automation Discussions
    Replies: 2
    Last Post: 06-07-2017, 16:14
  4. DOS Profile Setup Programming Question
    By marinereef in forum DŌS & DDR – Dosing and Fluid Metering System
    Replies: 12
    Last Post: 06-17-2015, 18:08
  5. Automatic Water Change (AWC) setup with DOS
    By milonedp in forum DŌS & DDR – Dosing and Fluid Metering System
    Replies: 4
    Last Post: 12-29-2014, 09:16

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •