ATK pump using 1Link

[Leeduncan986]

Not sure if I’ve posted this in the right section so apologies if it’s in the wrong place.

I’ve recently bought the wav starter kit and noticed that the 1 link has 2 ACC ports so I’m thinking of using that to power my ATK pump and wondering what coding I would need to use for it to work correctly?

i did have a search at the top but couldn’t find any posts already asking so any help would be much appreciated.

[RussM]

Yes, you can use a DC24/ACC output to power the PMUP. But you will (partially) forego the ability to use the ATK Task. It’s best to use the ATK the way it’s intended - with the included power supply and PMUP plugged into the FMM.

If you really don’t want to use the ATK power supply, what you can do is to run the ATK Task, which will program the FMM’s 24VDC output. You then must copy the programming created by the Task from the FMM’s 24vdc output to the 1LINK module’s 24vdc output where you plugged in the PMUP. Lastly, you need to remove the programming from the FMM output and replace it with Set OFF.