I have my 2016 Apex set up to run off a UPS with a 12v power to the Apex in the house socket so I can detect power outages.
Since the heater will suck the power very quickly, I'd like to set the temp several degrees below the normal temp to conserve power and increase available oxygen. I think I have the programming right, but wanted to post here in case I messed something up. Basically created a VO for the power out temp range (73.5-74) and one for the normal range (77.5-78). If either are ON, then the heater outlet is turned on. The normal range VO is shut down if a power outage is detected. Any advice on temp ranges or gotchas in my code would be appreciated!
Thanks!
VO: [HeatNoPower]:
If Tmp < 73.5 Then ON
If Tmp > 74.0 Then OFF
VO: [HeatWPower]:
If Tmp < 77.5 Then ON
If Tmp > 78.0 Then OFF
If Power Apex Off 000 Then OFF
Heater EB832 outlet:
Fallback OFF
Set OFF
If Output HeatNoPower = ON Then ON
If Output HeatWPower = ON Then ON
Bookmarks