Help with Fusion Dashboard icons

[jonleon89]

I have a ATK module with 4 optical sensors connected to it.

Switch 1 = SmpLow
Switch 2 = SmpHgh
Switch 3 = NewSlt
Switch 4 = OldSlt

For some reason my switch 1 has turned into FLX8_1 (which I think is for a flow meter). How do I fix this? This has happened before and corrected itself but this time it hasn't changed back yet. Any suggestions?

[jonmos75]

Make sure that the sensor is fully seated into the port. The bezel might be getting in the way so the sensor is making some contact, but not all the way.

[jonleon89]

I tried that. It was plugged in all the way. But sometime in the night Fusion deleted the FLX8_1 tile and added the old SmpLow as a new tile for me to add again

[rkpetersen]

Go to the FMM module page and manually configure sensor 1 to optical sensor, rather than the default auto-detect. (I'd do the same with the others as well.)

[jonleon89]

Thanks for the help! that was the problem. The auto detect was set to Flow meter instead of optical sensor

[rkpetersen]