Folks, I use the Osmolator for my ATO, but every time I turn off the return pump for feeding and then later back on, it runs wild until the water level in my sump normalizes. I can't put the osmolator on a controlled outlet because it does a pump priming run every time it is given power anew. My planned solution is to intercept the power to the pump itself for 5 minutes after anytime the return pump is turned on. I've successfully installed an electrical relay in the wire to the pump with the pump attached to the 'normally on' path. The control channel on the relay is 24V so I've wired that to the DC24 port. When the DC24 is turned on, the relay switches to the off position thus killing power to the pump.
To my question: I'm sure it's not complicated, but what would the code be to turn on LinkA_2_9 for 5 minutes any time RETPUMP_2_3 is switched on?
Many thanks!
Bookmarks