I have an optical sensor (ATO_LO) to sense when my ATO reservoir is low and want to program apex to send an alarm when the water level drops below the sensor. I changed the programming for base_emal and added the last line in the program below:
Set OFF
If Sump_H CLOSED Then ON
If FeedA 005 Then OFF
If FeedB 005 Then OFF
If Error FMM-24V Then ON
If Leak_d CLOSED Then ON
If Skimma OPEN Then ON
If ATO_Lo OPEN Then ON
But when I do that I start getting repeated alarms every 10-15 seconds saying "Status: OFF, Statement: Set OFF" I can stop the notifications by deleting the line I added then I don't have the alarm.
What's going on? And as an aside, why does Apex use such an antiquated method for programming alarms instead of simply programing alarm conditions directly at the input?
Untitled.png
Bookmarks