I am in the process of setting up my apex and am having trouble with my temp probe not being recognized and not being shown on my display or in Fusion. For reference, my temp probe is connected to a PM1 and the temp port on the head unit is empty. I have verified that the temp port on the head unit works as I have tried plugging an additional temp probe into the head unit to see if I get a reading and it does.
Additionally, I am getting error messages because the default temp is 20* and is what is shown on my display. I have combed over the Comprehensive Reference Manual (CRM) and am having a hard time understanding how I can correct this issue.
I am sure that it is something that I don't have configured right but for the life of me I do not know what or how to correct it.
I am sure that I will have a million other questions with this system like where is says on page 96 of the manual under "PM1 Probe Expansion Module" where they indicate that there is a webpage that displays the Module Status. I can't find it. Or on page 128 where it tells you that you can check the software revision of your AquaBus modules to insure you have the latest firmware but there is no information on how to get to the "Configuration- Module Setup" screen. I have looked in Fusion and I have looked on my display for these setup screens but I surely did not find them.
Anyway, if you can help me with getting my temp probe working I would really appreciate it.
Thank you,
Tom
Bookmarks