Hey everyone, I was wondering if anyone knew how to program my alarms on my Apex Classic such that they would not trigger if the ATK has been on in the past ten minutes? They keep triggering because the ATK drops some cold water (inconsequential to my water volume - but near my probes- which cannot be moved). My current alarm codes read as the following:
Set off
if temp > 82.0 then on
if tmp < 75.0 then on
if pH >8.50 then on
if pH <7.70 then on
If error ATK then On
If Swx4_2 closed then On
Defer 005:00 then On
Thank you!
Bookmarks