I have a pmup setup to work as an ato. I have an optical sensor on a virtual outlet and when the outlet turns on the pmup is supposed to turn on. When I am looking through my log sometimes the pmup turns on as soon as the optical outlet turns on. SOmetimes it take a few mintues before the pmup turns on. Any idea why it doesnt turn on right away when the optical turns on? Seems to me like the pmup should come on the second the optical outlet turns on but his is not hte case and I cant figure out why. Any help would be appreciated
Here is My PMUP Programming
Fallback OFF
If Output Optical-1 = ON Then ON
OSC 000:00/000:30/003:00 Then ON
If Output Optical-1 = OFF Then OFF
If Output ReturnPump = OFF Then OFF
If Salt < 20.0 Then OFF
If Output ATO-Lo = ON Then OFF
If Output DOS1-NSW = ON Then OFF
If Output DOSFillSalt = ON Then OFF
If Output Optical-2 = ON Then OFF
If Output Sump-LOW = ON Then OFF
If Output WaterChange = ON Then OFF
Min Time 000:20 Then ON
When On > 005:00 Then OFF
The Optical Switch Outlet Programming
Fallback OFF
Set OFF
If Opt-1 OPEN Then ON
If Output WaterChange = ON Then OFF
Defer 001:30 Then ON
Min Time 000:30 Then OFF
When On > 060:00 Then OFF
And my data log
21 2017-12-02 03:26:00 -0700 PMUP ON 22 2017-12-02 03:26:22 -0700 Optical-1 OFF 23 2017-12-02 03:26:22 -0700 PMUP OFF 24 2017-12-02 04:10:32 -0700 Optical-1 ON 25 2017-12-02 04:10:47 -0700 Optical-1 OFF 26 2017-12-02 04:12:42 -0700 Optical-1 ON 27 2017-12-02 04:14:06 -0700 Optical-1 OFF 28 2017-12-02 04:17:04 -0700 Optical-1 ON 29 2017-12-02 04:17:53 -0700 Optical-1 OFF 30 2017-12-02 04:20:06 -0700 Optical-1 ON 31 2017-12-02 04:22:00 -0700 PMUP ON 32 2017-12-02 04:22:10 -0700 Optical-1 OFF 33 2017-12-02 04:22:21 -0700 PMUP OFF
Bookmarks