I keep seeing reference to "display," and am wondering if I am supposed to be using a Neptune display for this phase of setting up my Apex. I am trying to set up my WXM module to run 2 Vortech MP60's and 6 Radion XR15 Gen 4 Pro's than are currently running with an EcoTech Reeflink. The directions say to plug module into the base unit, it will flash yellow as it initializes, then go solid green. What I get is an orange flash, then a steady orange on the status. No clue where to go to configure the thing, since under the probes tab, no reference to WXM shows, as I don't think the base unit knows the module is even there. What do I need to do to make the module "findable" by the base unit? The directions I've found thus far spend a lot of time with firmware updates...but the Apex has been updated, and the VorTechs are QuietDrives, so their firmware is adequate, as far as I know.
Bookmarks