Results 1 to 2 of 2

Thread: PH probe in PM1 problem

  1. #1
    New User
    Join Date
    Oct 2017
    Location
    Poland
    Posts
    12

    PH probe in PM1 problem

    Hi, I bought a PM1 module to may Apex 2016. I connected the PH probe to the PM1 module and calibrated, it works. ORP2 is disabled. The problem is that I see the PH2 probe and can read it but I can not program it, there is always error informing me that the words (PH2, PH2tank, PH-CAR and other that I used) are not valid. In the base unit I have ph robe (connected to the reactor) a ORP probe - both works corectly.

  2. #2
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    I had that problem once. I fixed it by renaming it to a temporary word, submitting, rebooting, changing back to the name I wanted, then rebooting again.

    You might be an engineer if...You have no life and can prove it mathematically.

Similar Threads

  1. PM1 problem with PH
    By kolalysy in forum Fluid Monitoring Module (FMM), FMK, ATK, LDK, and FMM Accessories
    Replies: 1
    Last Post: 12-02-2023, 04:15
  2. Pm1 ph port problem
    By M5dan in forum Apex Classic/Apex Lite/Apex Jr
    Replies: 4
    Last Post: 06-08-2019, 17:17
  3. PM1 problem
    By Fdnavy in forum AquaBus Modules, Probes, and Breakout Boxes
    Replies: 8
    Last Post: 03-12-2018, 16:59
  4. PM1 problem
    By blbradshaw in forum AquaBus Modules, Probes, and Breakout Boxes
    Replies: 1
    Last Post: 03-26-2016, 13:53
  5. Question: PM1 Module Problem.
    By fraggy in forum AquaBus Modules, Probes, and Breakout Boxes
    Replies: 2
    Last Post: 04-26-2014, 18:59

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •