Apex display blinking blue w/no info displayed after power outage

[Poi Dog]

Hello,

I had a power outage last night and when I woke up this morning my Apex display was blinking (slowly) blue and blank. I can still control the unit via the Internet interface but the display shows nothing. I see that the yellow and green lights on the module are still working.

I’ve tried unplugging the USB (powering down) the display but the blinking persists.

Appreciate any assistance on getting the display working again.

Dan

[zombie]

Try updating the display firmware. That often fixes blue screens.

You might be an engineer if...You have no life and can prove it mathematically.

[Poi Dog]

Thanks Zombie. After blinking for 2 days, this morning the display was working fine. I donno but it worries me. I see that there is a new version available so I'll update the firmware ASAP.

[zombie]

The system firmware won't make a difference for this issue. It's the module firmware that will. Most people skip over that step whenever they update and can cause problems.

You might be an engineer if...You have no life and can prove it mathematically.