Results 1 to 3 of 3

Thread: ATK Errors

  1. #1
    Frequent Visitor
    Join Date
    Jan 2013
    Location
    New Jersey
    Posts
    160

    ATK Errors

    Installed the ATK integrated with my Apex a week ago. Today I keep getting Status: ON Statement: If Error ATO-Garage Then ON alerts that are then shutting down my ATO pump. How do I figure out what this error really is, since the alert 'ERROR' is pretty useless.

  2. #2
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    It means that it ran longer than the when statement and shut the pump to manual OFF (default 5 minutes). If using a PMUP with a 50 gallon or smaller sump, 5 minutes should be fine and ypu probably have a clog, dirty sensor, kink, etc that needs to be investigated. If using a smaller pump or gravity feed with solenoid, a ton of head pressure on the PMUP, or a very large sump, the 5 min default needs to be increased.

    You might be an engineer if...You have no life and can prove it mathematically.

  3. #3
    Frequent Visitor
    Join Date
    Jan 2013
    Location
    New Jersey
    Posts
    160
    I inspected the entire setup and found the included tubing just is not a very snug fit for the PMUP itself. It had come loose and when I attached it came off immediately. I will be replacing it with a slightly tighter fitting tubing to ensure this doesn't happen again.

Similar Threads

  1. ATK Errors
    By jsbzcmcdaniel in forum Apex Programming for Dosing, ATO, and AWC
    Replies: 7
    Last Post: 08-30-2019, 19:22
  2. Help! ATK Errors
    By jcherepo in forum Apex Programming for Dosing, ATO, and AWC
    Replies: 3
    Last Post: 06-06-2018, 09:33
  3. ATK Errors
    By stubro in forum Fluid Monitoring Module (FMM), FMK, ATK, LDK, and FMM Accessories
    Replies: 7
    Last Post: 04-16-2018, 14:47
  4. ATK Errors/issues
    By Debacle in forum Fluid Monitoring Module (FMM), FMK, ATK, LDK, and FMM Accessories
    Replies: 6
    Last Post: 08-21-2017, 07:05
  5. Help! ATK Errors
    By amartin311 in forum Fluid Monitoring Module (FMM), FMK, ATK, LDK, and FMM Accessories
    Replies: 2
    Last Post: 08-20-2017, 07:23

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •