Hi guys
just noticed my temperature was mucking about , could someone let me have the basic cording for one stand alone heater, I was trying to put 79 on 80 off , but it won’t let me , it keeps saying must be below 37 what am I missing
thanks
Hi guys
just noticed my temperature was mucking about , could someone let me have the basic cording for one stand alone heater, I was trying to put 79 on 80 off , but it won’t let me , it keeps saying must be below 37 what am I missing
thanks
sounds like your probe is configured for centigrade but you are trying to control to fahrenheit. Check out the probe setup to make sure it is set to the units you need and your code is using the same scale.
As for simple code, it is in the reference manual which can be downloaded from the Neptune Links at the top of the page.
Thanks think you’re right , is there an easy way to centigrade to Fahrenheit
thanks
I think you need to use the probe setup page in the classic dashboard.
Bookmarks