I've tried everything I can think of and I still my 2016 Apex wont find my second Wav. I've tried everything I can think of swapped the wavs over on 1Link to prove it wasn't that but the other works in the different socket on the 1link so I'm at a loss.
All software including AOS is up to date.
The sequence below worked up to the step where the second Wav was plugged in but never showed up on the modules list, so of course I couldn't of update the firmware Wavs are just under 12 months old now worried I'll lose the second one too.
1 Disconnect the 1Link from the apex by removing the aquabus cable and power supply. Wait for 30 seconds to a minute.
2 Disconnect both WAV pumps from the 1Link
3 Go into apex classic dash and delete the 1Link module as well as any WAV module showing the "Module Setup Page"
4 Connect the 1Link Aquabus cable into the 1Link and wait for a solid green status light
5 Go into module setup page and update the 1Link module firmware, wait for this to complete successfully
6 Plug in the power supply to the 1Link
7 Connect 1 Wav pump to the 1Link, wait to make sure it shows up in "Module Setup Page"
8 Update the Wav Modules firmware
9 Plug in 2nd Wav pump to 1link. Make sure it shows up in "Module Setup Page", update Wav firmware
Any pointers as to what might be the issue?
Thanks all
Bookmarks