Hi
I have bought a new 2016 Apex and a Pmk par metering kit, when i should install it it says i need a display, something that are not included in the new Apex. Is this a joke or could i get around it?
Hi
I have bought a new 2016 Apex and a Pmk par metering kit, when i should install it it says i need a display, something that are not included in the new Apex. Is this a joke or could i get around it?
You do not need a display module. After you connect the ASM, go to the Modules page in either Apex Local or Apex Fusion. Select the ASM, then choose Configure from the Action menu. The Probe Type should already be set to ‘Par’; change it to Par if needed. Then click the Send button.
Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.
Thanks Russ, when I have done that, where to monitor the actual par readings in fusion?
I am not sure, but did you check the new tile area in fusion? You press the lock symbol at the top right to open the unused tiles then drag it to where you want it to show in fusion.
Bookmarks