Originally Posted by
zombie
Fallback OFF
Set OFF
If Sw1 CLOSED Then ON
If Sw1 OPEN Then OFF
If Sw2 OPEN Then OFF
Defer 000:10 Then ON
Defer 000:10 Then OFF
When On > 003:00 Then OFF
Min Time 150:00 Then OFF
That line is redundant, which is why I removed it in the code I gave earlier. The set OFF handles the sw1 open condition.
Double check your connections and make sure the float is changing states when you push it up or down (keep in mind fusion updates like every 30 seconds so you have to hold it for a bit). You might have a short in the way you connected it or it might be too close to a magnet and is holding the reed closed
You might be an engineer if...You have no life and can prove it mathematically.
Bookmarks