I had an error with my ATK, the module was flashing so i unplugged it (power and usb) and plugged it back in. The pump turned on and none of the fail safes caught it. Luckily i was watching it and saw it happen - i let it run until it was just over optic2 sensor just to see if it would turn off, it didnt and i had to unplug it. Any ideas? Below is my code.
Fallback OFF
Set OFF
If optic1 OPEN Then ON
If optic2 CLOSED Then OFF
If WTRCSW CLOSED Then OFF
If ATOSW CLOSED Then OFF
If Output FEED_10MIN = ON Then OFF
If Output waterchange = ON Then OFF
If Output waterchange2 = ON Then OFF
If LeakTA CLOSED Then OFF
When On > 002:30 Then OFF
Defer 000:15 Then ON
Defer 000:05 Then OFF
Min Time 015:00 Then OFF
Bookmarks