This is a two part code for my skimmer and then my power heads. I want to temporarily set up my skimmer to shut off at night to prevent any possible overflowing (it's a HOB and brand new on a nano tank) plus with feeding cycles programmed on my power head and defer 10 mins prior to restarting.
I would also like to have my power heads outlet to surge on few 10 secs after the feed cycles A & B end then shut off for 2 mins, but I cannot figure out the surge and stop part.
Any help on these 2 programs will be greatly appreciated!
Outlet: Skimmer_7
Fallback OFF
Set ON
If Outlet POWERHEADS_1 = OFF Then OFF
If Outlet POWERHEADS_1 = ON Then OFF
Defer 10:00 Then ON
If Outlet MoonLight_6 = OFF Then OFF
If Outlet MoonLight_6 = ON Then ON
Outlet: POWERHEADS_1
Fallback ON
Set ON
If FeedA 000 Then OFF
(cannot figure out how to start for 00:10 then off for 02:00 then turn on)
If FeedB 000 Then OFF
(cannot figure out how to start for 00:10 then off for 02:00 then turn on)
If FeedC 000 Then OFF
If FeedD 000 Then OFF
Bookmarks