I know they supply BSPP to SLIP unions for the 1" flow sensor, but I like my plumbing as clean as possible.
I am adding UV Sterilizer with 2" slip fittings, so if I could find a Slip / BSPP reducer I would be in heaven. I'd also need a BSPP (Female) to Barb fitting. I'm too picky I know.
I purchased two of FMM units for my DIY Water Changer. I was using floats, but one failed a few months ago, that's why I'm going to add the flow sensor. The magnets are handy for holding the optical sensors, but I don't really trust them. I need to build a DIY holder, but no epiphanies so far.
I'm using one optical sensor as my Top Off shutoff (backed up with a timer and overflow drain), my second sensor is the shutoff for my bilge pump (backed up with a timer and a third sensor below the filter input), my third sensor is below the filter input and shuts off the filter and sends an email alert if activated. The flow sensor will do the same if the filter fails; shut off the filter and send an email alert.
I also have a sensor in the tank which shuts off the filter if the water in the tank gets too high (overflow failure) and sends an email alert. I also have a Water on Floor sensor on the 2nd FMM. No connections for the last two inputs. YET.
Bookmarks