How can I code for flow activity in a rodi line if the neptune solenoid is in the OFF position? I want to get a heads up if the solenoid fails and water comes through the line. I have a 1/4 inch sensor on the line and im stuck because theres no "and" statements.
This is what im hung on so far in the virtual outlet alarm I made:
Set OFF
Fallback OFF
If RODI > 0.0 Then ON
??????????????
I really want the "and" capability directly after the last command above, and would use it for: "AND outlet Solenoid = OFF"
But theres no "and" - so how can this be done?
Bookmarks