I clicked the padlock but they werent there also. I have the email alert OFF AUTO ON tab though.
I clicked the padlock but they werent there also. I have the email alert OFF AUTO ON tab though.
Tiles for these outputs are not shown unless you have a display module connected.
Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.
Turn off the alert setting on your orp input settings, or configure the values for a proper level based on your orp values.
I was going to post the same question.... I had them on my dashboard when I first set up the unit (without any display), but moved them up to the lockbox to unclutter while I was learning/setting up. I went back into the lockbox to drag them back out and they are nowhere to be found.
I had/have same issue. Guessing the Alarm and Warning tiles come pre-loaded and once fusion recognizes that there is no display unit hooked up, the tiles disappear.
Well there ya go. Thanks Russ
Bookmarks