Results 1 to 2 of 2

Thread: ATK pump connector to the FMM

  1. #1
    Regular Vistor
    Join Date
    Aug 2017
    Location
    Oceanside, CA
    Posts
    37

    ATK pump connector to the FMM

    Okay today like an idiot I swapped out ATO containers. I had to disconnect the ATK pump from the FMM and in doing so the plastic that surrounds the probes that you plug into the FMM broke off. So now I can't get the ATK to work. Is this the reason why it's not working or could it be something else. was working properly before this mishap. I already ordered a new pump just in case, but thought I'd ask as well.

  2. #2
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    It's very likely. You will find out for sure when the replacement shows up.

    You might be an engineer if...You have no life and can prove it mathematically.

Similar Threads

  1. Review My Program FMM module and ATK pump
    By asulistyo in forum Apex Programming for Dosing, ATO, and AWC
    Replies: 3
    Last Post: 11-04-2020, 00:05
  2. Question: Using DOS to replace ATK pump on FMM
    By Aidz740 in forum DŌS & DDR – Dosing and Fluid Metering System
    Replies: 0
    Last Post: 04-12-2020, 15:17
  3. ATK except without FMM
    By Andy_H in forum Pre-Sales Questions
    Replies: 3
    Last Post: 09-19-2019, 12:59
  4. ATK with (2) FMM
    By Reefinny in forum Fluid Monitoring Module (FMM), FMK, ATK, LDK, and FMM Accessories
    Replies: 10
    Last Post: 11-26-2017, 08:57
  5. 2 months old wav pump is broken in 1link power connector
    By Andrass1989 in forum WAV Powerheads
    Replies: 2
    Last Post: 10-30-2016, 09:13

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •