Can't See ORP Probe

[Flexin]

Hi everyone.

I have had my classic running since December, no problems. I ordered an ORP probe, took the cap off, placed it into the sump securely, and plugged it in. My fusion screen originally read the second outlet as PH2 and continues to do so. How do I get it to recognize or change this to ORP?

[zombie]

You need to reconfigure it for ORP in the probe setup of the classic dashboard.

You might be an engineer if...You have no life and can prove it mathematically.

[Flexin]

Corrected by resetting the APEX Classic. Once done the probe was immediately recognized. Steps below.

Check 3) Make sure you have DHCP setup correctly

If those are fine follow these steps below.

1. Check to make sure DHCP is enabled on your controller and restart the controller
   
   1. On your Apex Display screen: SYSTEM> NETSETUP> DHCP (Turn this ON)
   2. Then scroll up on the NETSETUP MENU and go to RESTART.
   3. This will cause your display to go blank. Wait for it to finish and return.