Results 1 to 3 of 3

Thread: AFS Not Responding to Manual ON

  1. #1
    Regular Vistor
    Join Date
    Nov 2014
    Location
    Breckenridge, CO
    Posts
    20

    AFS Not Responding to Manual ON

    My AFS module won't respond to manual ON mode. I am not sure about AUTO because I am out of the country and cannot check it personally. I have a tank sitter who is there when I manually turned it on and he is said it is not moving and I can hear that it isn't via my DropCam(because it is so nice and loud when operating ). The light in the back is green and Fusion does tell me whether or not the module is connected or disconnected as the Aquabus is plugged/unplugged from the back. I have tried both ports in the back, checked firmware updates, and rebooted the Apex through the MISC tab in Fusion to no avail. All firmware is up-to-date for the 2016 Apex and all modules. Does anybody have any other ideas?

  2. #2
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    Perhaps pull the container out and see if it will run then. Possible the gear got clogged up or seized.

    You might be an engineer if...You have no life and can prove it mathematically.

  3. #3
    Regular Vistor
    Join Date
    Nov 2014
    Location
    Breckenridge, CO
    Posts
    20
    I tried that and had my tank sitter tap it upside down a few times to see if anything would dislodge and come out, but nothing did. He is pretty mechanically inclined and couldn't see anything obvious. I had him hold the mechanism while I turned it on and he couldn't feel anything moving around in it. I will just have to take it apart when I get home. Thanks for the advice anyways!

Similar Threads

  1. Help! WXM/Radions and AFS on Aquabus Not Responding
    By dhaen in forum A2 Apex/ApexEL and A3 Apex Pro/Apex/Apex Jr
    Replies: 1
    Last Post: 03-17-2017, 21:50
  2. Help! AFS not responding to Apex outlet
    By jharding08 in forum Apex Classic/Apex Lite/Apex Jr
    Replies: 2
    Last Post: 08-03-2016, 06:28
  3. Review My Program AFS Manual Code...
    By MatroxD in forum AquaBus Modules, Probes, and Breakout Boxes
    Replies: 7
    Last Post: 12-17-2015, 12:55
  4. AFS with Manual Feed Button
    By bkpky in forum Misc Apex Usage & Programming
    Replies: 8
    Last Post: 06-03-2014, 16:18
  5. AFS: Setting a delay after a manual feed cycle starts
    By SteveW25561 in forum Misc Apex Usage & Programming
    Replies: 2
    Last Post: 03-25-2014, 20:56

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •