Hi... I am trying to measure my Doser current load that is located in the EB8 3.4 Outlet but it doesn't appear in the pull down menu. It is flagged in the outlet log. Is it because the low current draw?
Any suggestions?
Hi... I am trying to measure my Doser current load that is located in the EB8 3.4 Outlet but it doesn't appear in the pull down menu. It is flagged in the outlet log. Is it because the low current draw?
Any suggestions?
Screens for evidence...
An EB8 does not have per-outlet power measurement.
Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.
Thanks Russ. Yes i am aware of that but i am looking to add the Doser as the other outlets that are in the graph. That will tell me the on and off cycle when the pumps turn on.
Here is an example of the lights graph.
Have you tried sliding that selection screen up? Might be hidden.
Sent from my iPhone using Tapatalk
Yes. It does not show up neither if i enter Doser in the search box.
Look in the output logs. Does the outlet show up there?
Sent from my iPhone using Tapatalk
No. Actually that may be a point. Today was that I selected the Doser to report the log so maybe that is why it doesn't appear.
This morning todays log was blank and now I see that the ATI Bulbs have an entry at 1300. Probably it needs more time in order to report the entry but the Doser is on 24/7.
I am going to do a test and shut it off to see if it registers.
Resolved... I turned it off and on again and it registered.
Thanks to all.
Bookmarks