This is my first week of using Apex so please bare with me.
I have my water change set on FeedD. I’m turning off everything in my sump including my heaters. Sw3bot is my fail safe float if the water levels get low in my sump.
(Heater1 and Heater2 Code)
Fallback OFF
If Tmp < 78 Then ON
If Tmp > 78.5 Then OFF
If Sw3Bot CLOSED Then OFF
If FeedD 030 Then OFF
1st question, if I start FeedD and the temp is below 78 will my Heater still come on? When does Apex stop reading the code if there are more than one value that is True?
2nd Question. Is having a .5 F range ok or should I widen the on and off range between temperatures? Ie: 78 to 79
Thanks
Sent from my iPad using Tapatalk
Bookmarks