Description: My NSW tank is located about 3 feet above my sump. I run a 70' line to my DOS pump under my tank. I don't want to have a possible siphon should something in the DOS pump fail.
Desire: I've got a 24VDC normally-closed valve I can install on my NSW feed line. I'd like Apex to open this valve when the DOS pump turns on, and close it 1 minute after the DOS pump has finished adding new salt water.
Relevant details: My new saltwater pump is named "NSW" in Apex. The 24VDC valve is named "NSW_Valve" and the output is configured as "advanced". My 24VDC valve is located at 24V Accessory Output A on the EB832 named EB832_2 at Aquabus address 2.
Problem: My code isn't working! I have the following code in the "advanced" tab of NSW_Valve:
Set OFF
If Output NSW = ON Then ON
Defer 001:00 Then ON
This doesn't seem to be working. NSW_Valve shows as always on.
What have I done wrong?
Thanks!
Bookmarks