So I recently purchased the Jebao apex harness and completed the programming for it. The left channel works fine with either powerhead; however, the right channel doesn't come on at all, even when in the "ON" position on Fusion. I am at a total loss.
Programming below:
Timer_1
OSC 120:00/010:00/000:00 Then ON
If Output Timer_2 = ON Then OFF
If Time 23:00 to 11:00 Then OFF
Timer_2
OSC 045:00/015:00/000:00 Then ON
If Output Timer_3 = ON Then OFF
If Time 23:00 to 11:00 Then OFF
Timer_3
OSC 015:00/005:00/000:00 Then ON
If Output Timer_1 = ON Then OFF
If Time 23:00 to 11:00 Then OFF
VarSpd1_l1
Set Wave1
If Time 11:00 to 14:59 Then DuskDawn
If Time 15:00 to 21:59 Then Lt_Flush
If Time 22:00 to 23:59 Then DuskDawn
If Time 00:00 to 10:59 Then Night
If Output Timer_1 = ON Then DblFlush
If Output Timer_2 = ON Then Pulse
If Output Timer_3 = ON Then Wave2
VarSpd2_l2
Set Wave1
If Time 11:00 to 14:59 Then DuskDawn
If Time 15:00 to 21:59 Then Rt_Flush
If Time 22:00 to 23:59 Then DuskDawn
If Time 00:00 to 10:59 Then Night
If Output Timer_1 = ON Then DblFlush
If Output Timer_2 = ON Then Pulse
If Output Timer_3 = ON Then Wave2
All the profiles listed were setup with the exact names referenced above.
Troubleshooting so far:
- Turned VarSpd VO's to ON (only the l2, right side, worked)
- Swapped pumps. Still only l2 worked. The pump that was working stopped and the one that wasn't working now worked.
- Moved to VarSpd 3 and 4 with same programming. Same issue.
- Replaced the ethernet cable... BOOM! Worked! Should have done that in the first place
Bookmarks