Hi All,
I am hoping to get a little input from more experienced eyes/hands. I am setting up my apex classic after it has been in storage for quite some time. Everything so far is running pretty well. I upgraded to the most recent firmware and updated my modules (2 eb8’s, and the display module).
My issue is with the temperature probe. I think it was working for a bit but recently jumped “WAY OUT OF RANGE” - 120 degrees +. I think this is likely due to a short but I can’t be sure.
When I went to calibrate it, the interface would only allow me to move the range a maximum of 30 degrees before recycling back to the upper range - eg 102-132 - is that normal? Also, they were in whole numbers - no 102.6 for example.
I can certainly buy a new probe but I am not sure if that will fix my problem if I can’t calibrate it effectively or if the “guts” of the apex are amiss.
Thanks very much for your help.
Bookmarks