So tonight I measured a DKH of 14 or meg/l of 5.00.
Trying to enter this in with the Red Sea kit selected... I can only enter in a reading at a low of .38 or a high of 1.0. This doesn't match anything the kit tells you.
If I enter 1.0 it gives a result of 14dKH which is what I measured. This makes zero sense.
exhibit A to show this:
dkh1jpg.jpg
Then if I Set the Test Kit to None I can choose what reading, be it dKH, meg/L, or ppm.
In this case if I choose to record meg/L and enter in 5.00 (based off the test results) it will show a result of 14dKH which is right.
dkh2.jpg
If I choose to enter dKH it just returns a result of 14 dKH doesn't convert it to meg/L.
dkh3.jpg
Am I missing something with the Red Sea test kit entry? Or should I stick to a Test Kit of "none" and then enter in the meg/L converted from the test results?
or are these fields bugged?
Bookmarks