Results 1 to 4 of 4

Thread: Recalibrate DOS after new APEX installation?

  1. #1
    Frequent Visitor
    Join Date
    Sep 2013
    Location
    Rhode Island
    Posts
    146

    Recalibrate DOS after new APEX installation?

    I just upgraded my Apex from a Classic to a 2016. Do I need to re-calibrate my two DOS units or do they store the calibration data within the unit themselves? I've connected them to the new Apex via 1Link cable now if that makes any difference.

  2. #2
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    It's a good idea to calibrate every time you change a head or every couple months anyway, so it was likely due for a calibration anyway.

    You might be an engineer if...You have no life and can prove it mathematically.

  3. #3
    Master Control Freak RussM's Avatar
    Join Date
    Dec 2012
    Location
    California - US Pacific
    Posts
    22,466
    Quote Originally Posted by stre1026 View Post
    they store the calibrate data within the unit themselves
    This ^^

    However, if it's been a while since you last did a round of calibrations, there's no harm in doing it again.
    Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.

  4. #4
    Frequent Visitor
    Join Date
    Sep 2013
    Location
    Rhode Island
    Posts
    146
    Thanks guys. I just calibrated the units a few weeks ago so I should be all set. If I get bored, I may do it again.

Similar Threads

  1. My First Apex - New Installation
    By dbl in forum Apex Installation and Mounting
    Replies: 4
    Last Post: 09-29-2015, 07:42
  2. Apex Feeder installation help
    By cliff in forum APEX Fusion
    Replies: 3
    Last Post: 08-25-2015, 14:00
  3. Help! No DOS outlets created after installation
    By ReefPilot in forum DŌS & DDR – Dosing and Fluid Metering System
    Replies: 6
    Last Post: 01-06-2015, 12:44
  4. recalibrate ph probe
    By juice04 in forum AquaBus Modules, Probes, and Breakout Boxes
    Replies: 6
    Last Post: 11-17-2014, 05:53
  5. New Apex installation
    By davidfrances in forum Apex Installation and Mounting
    Replies: 9
    Last Post: 10-31-2014, 12:13

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •