How Would I Set The Leak Detection Probes Up In Apex To Turn Off Pump And Skimmer, If There Is A Problem? ... I have My Probes Plugged in to my ATO FMM Module.... ((This Is My First Post))
How Would I Set The Leak Detection Probes Up In Apex To Turn Off Pump And Skimmer, If There Is A Problem? ... I have My Probes Plugged in to my ATO FMM Module.... ((This Is My First Post))
You add the line
If probename CLOSED Then OFF
To the device you want turned off.
You might be an engineer if...You have no life and can prove it mathematically.
Welcome to the Neptune forum.
The leak detectors you installed will now correspond to the number 3 and 4 OPEN/CLOSED switches on your FMM. First, go to your Modules page in Apex Fusion, select the FMM module, and select Configure under the Configuration dropdown menu. Make sure 3 & 4 are set to Water on Floor Sensor, and uncheck the auto-detection boxes; then Update the Apex. (You can also rename each sensor to something informative from either the tile or the Inputs page, if you wish.)
The simplest way to then set the sensors to control each device is to add 2 lines to your return pump and skimmer code:
If leakprobe1 CLOSED Then OFF
If leakprobe2 CLOSED Then OFF
Thank You Very Much!
Works Like A Charm!
Bookmarks