Results 1 to 4 of 4

Thread: Feed mode

  1. #1
    Regular Vistor
    Join Date
    Sep 2016
    Location
    Eastern Time Zone
    Posts
    19

    Feed mode

    9C07DD0B-CA79-48DB-B011-2A19D1776ADF.png 29A627AA-5B22-42B9-84C7-857EA25C5A53.png

    When I put in the comman If feed under my viortech it turns it off. But when feed mode expires my vortech say missing on fusion and they come back on at a rate that is different then what I have them set at. The speed is much higher. I have them set at nutrient 40% but much higher and fusion says missing.

  2. #2
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    Don't put the Feed in the energy bar outlet. That should be always ON or just plugged into the wall and save the energy bar outlet. Instead put the Feed in the advanced tab of the MP40 wizard. You can even define a profile that is a slow pulse instead of OFF and this will help suspend the food but keep it moving slowly.

    You might be an engineer if...You have no life and can prove it mathematically.

  3. #3
    Regular Vistor
    Join Date
    Sep 2016
    Location
    Eastern Time Zone
    Posts
    19
    Where is the advanced tab of mp40 wizard?

  4. #4
    Regular Vistor
    Join Date
    Sep 2016
    Location
    Eastern Time Zone
    Posts
    19
    Nevermind. Found it zombie. Thanks for the quick and helpful reply.

Similar Threads

  1. M040 Feed Delay Then Start Feed Mode
    By CoralNerd in forum Apex Programming for Vortech, Tunze, & Other Controllable Pumps
    Replies: 3
    Last Post: 01-25-2019, 14:42
  2. Question: Feed Mode A - Turn on XF250 at a slow speed with ICE CAP wtih Alternating Gyre Mode
    By imfsub12 in forum Apex Programming for Vortech, Tunze, & Other Controllable Pumps
    Replies: 8
    Last Post: 05-01-2018, 18:27
  3. Question: I need help programming my MP10 and MP40 for feed mode/ nutrient transport mode
    By Koddie Doo in forum Apex Programming for Vortech, Tunze, & Other Controllable Pumps
    Replies: 5
    Last Post: 01-08-2018, 16:02
  4. Setting kessil mode during feed mode?
    By Turtles in forum Apex Programming for Lighting
    Replies: 1
    Last Post: 05-17-2017, 11:52
  5. Feed mode
    By Sthomasson72 in forum Apex Programming for Vortech, Tunze, & Other Controllable Pumps
    Replies: 2
    Last Post: 12-14-2016, 18:06

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •