Hello,
I currently have the COR go into feed mode for 7 minutes when I manually hit the button on the COR CONTROLLER to feed the corals, but I want the fish to be fed by AFS only according to my schedule below.
The AFS is giving food if I MANUALLY put the COR into feed mode by holding the button on the COR controller, I only want it to give food at the specified times. How do I stop this? Putting the COR20 manually in feed mode triggers the feeding sequence below.
I pasted my whole feed sequence below incase anyone needs it as well. Hopefully someone can please help me modify it to fix the problem above.
I have the AFS to feed 3 times a day at 9AM, 1PM, 5PM, single rotation.
Initiate Feed cycle —> COR feed speed of 1, skimmer OFF, pumps OFF —> wait 1 minute —> feed —> wait 10 min —> COR normal speed and pumps back on —> wait 5 minutes then skimmer ON
FEED_SEQ (virtual outlet):
Set OFF
If Time 09:00 to 09:01 Then ON
If Time 13:00 to 13:01 Then ON
If Time 17:00 to 17:01 Then ON
If FeedA 000 Then ON
AFS:
OSC 000:00/000:30/000:30 Then ON
If FeedA 000 Then ON
If Outlet Feed_Seq ON Then ON
Defer 001:00 Then ON
If ORP < 250 Then OFF
COR20: (stays at 100% except when feed mode then speed is 1%)
Fallback ON
tdata 00:00:00,0,0,100,0,0,0,0,0,0,0,0,0,0
If FeedA 007 Then 1
If Output Feed_Seq = ON Then 1
Defer 011:00 Then ON
PUMPS_OFF (virtual outlet):
Set OFF (pumps stay on)
If Output Feed_Seq = ON Then ON (pumps turn off)
Defer 011:00 Then OFF (pumps back on)
SKIMMER: (follows what the COR does)
Fallback OFF
Set ON
If Output COR_POWER = OFF Then OFF
If Output COR_PUMP Percent < 90 Then OFF
Defer 005:00 Then ON
Bookmarks